Sharp PN-L802B 사용자 설명서 - 페이지 3

{카테고리_이름} Sharp PN-L802B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp PN-L802B 13 페이지. Touchscreen
Sharp PN-L802B에 대해서도 마찬가지입니다: 운영 매뉴얼 (9 페이지), 운영 매뉴얼 (48 페이지), 설정 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (1 페이지), 빠른 시작 매뉴얼 (1 페이지), 빠른 시작 매뉴얼 (1 페이지), 빠른 시작 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (1 페이지), 수동 시작 (24 페이지), 보증 (2 페이지), 소프트웨어 설정 매뉴얼 (46 페이지), 연결 매뉴얼 (1 페이지), 브로셔 및 사양 (4 페이지)

Sharp PN-L802B 사용자 설명서
Getting Started
Federal Communications Commission (FCC)
Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with instructions contained in
this manual, may cause harmful interference to radio and television
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from that of the
receiver
Consult the dealer or an experienced audio/television technician
NOTES:
Connecting this device to peripheral devices that do not comply with Class B
requirements, or using an unshielded peripheral data cable, could also result in
harmful interference to radio or television reception.
The user is cautioned that any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to operate this
equipment. To ensure that the use of this product does not contribute to
interference, it is necessary to use shielded I/O cables.
2