Crestron WMKT-4000L 설치 매뉴얼 - 페이지 6

{카테고리_이름} Crestron WMKT-4000L에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron WMKT-4000L 12 페이지. Trim ring mount kits

Trim Ring Mount Kits

4 • Trim Ring Mount Kits: TMK-4000L & WMKT-4000L

Crestron TMK-4000L & WMKT-4000L

3. When the trim ring is in position, bend the top two flanges of the ring

upward and the bottom two flanges downward.

•

If mounting into the PMK-4000L, bend the flanges

approximately 90 degrees.

•

If mounting into the BB-4000L, bend the flanges back as far

as they can go.

4. Run the necessary cables for the touchpanel and secure them behind the

drywall.

5. The TPS-4000L can be installed using the four tapped holes in the

PMK-4000L or BB-4000L. Refer to the latest revision of the

TPS-4000L Operations Guide (Doc. 6301) for details.

WMKT-4000L Procedure

The procedure in this section provides the necessary steps for installation of the

WMKT-4000L into a wall. Complete the steps in the order provided. The only tools

or materials required and not supplied are a drywall saw or equivalent and a level.

1. Locate an area on the wall that is free of miscellaneous wiring and

studs.

2. Make a small hole near the middle of the designated site; verify that the

location is suitable.

NOTE: Make the cutout as level and smooth as possible. The mounting plate allows

for only minor leveling adjustments. If a larger cutout is accidentally made, consider

purchasing the Crestron Mud Mount Kit, MMK-4000L. It and the mounting plate

supplied with the WMKT-4000L provide a cost-effective means of correction.

Essentially, The combination of these two kits makes up the Crestron Mud Mount

Kit for the Wall, WMKM-4000L. Simply follow the "WMKM-4000L Procedure" in

the latest revision of the Mud Mount Kits Installation Guide (Doc. 6303).

3. Use the drywall saw or equivalent to produce a level, rectangular cutout

in the drywall (refer to the Drywall Cutout dimensions on page 2 for

cutout dimensions.).

4. Insert the symmetrical trim ring into the opening, as shown in the

following diagram.

Installation Guide – DOC. 6302