Digital Acoustics EDW-110 사용자 설명서 - 페이지 14

{카테고리_이름} Digital Acoustics EDW-110에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Acoustics EDW-110 16 페이지. Ed/es series ii3 ip intercom

E O

PTION

A PoE (Power over Ethernet - 802.3af compatible) option is available on all

models in the ED and ES lines.

• Each ED or ES intercom will draw 7 Watts from your network switch

or injector

• On models with the PoE and integrated 2-port switch options, PoE

does not pass through to other devices connected to the 2

• Do not plug power into the external power jack and connect the

Intercom to a PoE power source at the same time

ROUBLESHOOTING

Verify power connections. The "Active" or LD10 LED on should be on or

flashing.

Verify that the "Link" or LED is on solid. If not, a valid network

connection is not present.

ii3 Intercoms may operate across some firewalls or VPN's. They will

need to be configured locally (for setup) and will need to be assigned to

the STATIC IP addresses of the TalkMaster PC.

If the intercoms have been configured for DHCP and no DHCP server is

available, re-power the intercom while holding down the Volume Up and

Volume Down buttons. Wait 15 seconds, then Search for the Intercoms

again and assign a static IP address.

If you cannot detect any intercoms using the TalkMaster Intercom

Configuration Utility screen try directly connecting the PC (running

TalkMaster) to the ii3 intercom using a crossover cable (disconnected

from the network).

PC running

TalkMaster

To reset the Intercom's configuration back to factory defaults, re-power

the intercom while holding down the TALK and Volume Up buttons.

This will erase the Intercom's IP Address settings, Intercom Name and

all options. Wait 15 seconds, then Search for the Intercoms again and

re-configure the Intercom.

Crossover Cable

- 14 -

port

ii3

intercom