Sharp SJ-RF33E-SL 운영 매뉴얼 - 페이지 11

{카테고리_이름} Sharp SJ-RF33E-SL에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp SJ-RF33E-SL 24 페이지.

페이지 인쇄

Care and cleaning

Important

Follow the tips below to prevent cracks on the inner

surfaces and plastic components

• Wipe out food oil adhered to plastic parts.

• Some household chemicals may cause damage, so use

only diluted washing-up liquid (soapy water).

• If undiluted detergent is used or soapy water is not

wiped off thoroughly, it may result in cracks of plastic

parts.

Cleaning

For hygienic reasons, make sure to do following

things regularly.

■ Remove the accessories (e.g. shelves) from the cabinet

and the door. Wash them by warm soapy dishwashing

water. After that, rinse them in clean water and dry.

■ Clean the inside with a cloth soaked in warm soapy

dishwashing water. Then, use cold water to wipe off

soapy water thoroughly.

■ Wipe the exterior with a soft cloth each time it gets

dirty.

■ Clean the Magnetic door seal with a toothbrush and

warm soapy dishwashing water.

■ Do not put on the shelf on the protrusions.

■ Make sure to put the shelf on the rail.

The hooks of the shelf must be frontside and

downward.

If the shelf is not placed correctly, it may fall down.

Protrusions

Rail

Protrusions

■ Do not remove the air inlet of the freezer compartment.

If you remove them forcibly, it may cause deformation

of the parts.

Note

• After cleaning, make sure to put the shelves and the

cases on original position.

• Do not use heavy-duty cleansers or solvents (lacquer,

paint, polishing powder, benzine, boiled water, etc.)

which may cause damages.

• If you pull out the power plug once, wait 5 minutes at

least before connecting the power plug again.

• The glass shelves are heavy to carry. Hold them ﬁ rmly

when you remove the shelves from the cabinet.

• Do not drop objects inside the refrigerator or strike the

inner wall. This may cause cracks to inner surface.

Rail

Hook

Defrosting

Defrosting is automatically operated by a unique energy

saving system.

When the compartment light is blown

Contact the service agent approved by SHARP to replace

the light. The light is not to be replaced other than by

qualiﬁ ed service personnel.

Switching off your refrigerator

If the refrigerator needs to be switched off for an extended

period, the following steps should be taken to reduce the

growth of mold:

1. Remove all food.

2. Remove the power plug from the socket.

3. Clean and dry the interior thoroughly.

4. Keep all the doors open slightly for a few days to dry.

EN-9