Sharp SJ-XP39PGRD 운영 매뉴얼 - 페이지 12
{카테고리_이름} Sharp SJ-XP39PGRD에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp SJ-XP39PGRD 20 페이지.
![Sharp SJ-XP39PGRD 운영 매뉴얼](/uploads/products/server2/5055074/5055074.png)
INSTALLATION
WARNING
■ Do not install the refrigerator in a damp or wet
location. It may cause the damage to the insulation
and a leak. Dew may also appear on the outer cabinet
and it causes rust.
■ Connect the earth pin to the earth terminal properly.
1
Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum required space for
installing the refrigerator. The measurement condition
of power consumption is conducted under a different
space dimension.
• By keeping greater space, the refrigerator may be
operated under a less amount of power consumption.
• If using the refrigerator in the smaller space dimension
than the below figure, it may cause the temperature
rise in the unit, loud noise and failure.
60mm
or more
• The space between the rear of the refrigerator and the
wall should be 60mm or more and less than 75mm.
If the space is wider than 75mm, you may get injured
by touching compressor and its peripheral parts which
are extremely hot during the operation.
Overall space required in use
2
Use the two front Adjustable feet to place the refrigerator
flatly and firmly on the floor.
12
90mm
or more
60mm
or more
1160 mm
Adjustable foot
3
Remove the 2 screws of the lower part of the cabinet
and use these screws to set the foot cover. (At first, the
foot cover is inside the refrigerator compartment.)
NOTE
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not place
next to heat generating appliance.
• Do not place your refrigerator directly on the ground. Provide
suitable stand.
• To insert the power plug when the door is opened, door alarm
sounds but it is not abnormal. This sound stops when closing
the door.
When transporting
• The casters allow the refrigerator to move back and forth.
• Carry the refrigerator by holding the handles located on the
rear and the bottom.
Casters
SJ-XE35PM:2pcs.
SJ-XP39PG, SJ-XE39PM:
4pcs.
• Wipe up water in the evaporating pan. Before wiping up
the water, wait more than 1 hour after pulling out the plug
because refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Free standing type
Foot cover
Screw (2 screws)
rear
bottom
Evaporating pan