Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector 운영 매뉴얼 - 페이지 38
{카테고리_이름} Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector 49 페이지. Colour inkjet printer
Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector에 대해서도 마찬가지입니다: 운영 매뉴얼 (49 페이지), 기본 정보 및 준비 사항 (10 페이지), 운영 매뉴얼 (47 페이지)
페이지 인쇄
When the STATUS Indicator Illuminates or Flashes
Status Light Messages
Condition
OFF
On Continually
Flashing Very Rapidly (On and
off in a cycle of 1 sec.)
Flashing Rapidly
(On and off in a cycle of 4 sec.)
Flashing Slowly (On and off in a
cycle of 8 sec.)
Flashing Very Slowly (On and off
in a cycle of 12 sec.)
36
STATUS indicator
POWER
STATUS
ON/OFF
INPUT SELECT AUTO SYNC
Status
Normal
The lamp usage has exceeded 1000 hours of operation and should be
replaced.
• The lamp cover is not correctly attached. Replace it correctly.
• The temperature protector has been triggered. If the room temperature is
high, move the unit to a cool location. If the temperature within the unit is
high, check the cooling fan (exhaust vent) and the cooling fan (exhaust
vent) on the bottom of the unit. If any of the slots are blocked, remove
whatever is blocking them.
• The temperature protector has been triggered. If you try to turn on the
unit immediately after turning off, sometimes the power does not come
on. If this happens, wait at least one minute, then turn on the unit again.
• The lamp lighting voltage error detection protector has been triggered.
Wait at least one minute before turning on the unit again. If this does not
solve the problem, please contact your dealer.
The cooling fan has stopped. Contact your Sharp Authorized LCD Projector
Dealer or Service Center.
The lamp is not turned on.
• The unit was turned on immediately after being turned off. Turn off the
unit, wait at least one minute, then turn on the unit again.
• The lamp is dead. Replace the lamp cage. (See page 37.)