Sharp Notevision PG-D3050W 설정 매뉴얼 - 페이지 17

{카테고리_이름} Sharp Notevision PG-D3050W에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision PG-D3050W 26 페이지. True wxga data projectors and short-throw true wxga data projector
Sharp Notevision PG-D3050W에 대해서도 마찬가지입니다: 운영 매뉴얼 (9 페이지), 빠른 매뉴얼 (2 페이지), 사양 (2 페이지)

페이지 인쇄
Sharp Notevision PG-D3050W 설정 매뉴얼

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in
"Address" on Internet Explorer (version 6.0 or later) using a computer on the network to
start a setup screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer
Complete connections to external
equipment before starting the operation.
(See pages 21-25 of the projector's
operation manual.)
Complete the AC cord connection. (See
page 25 of the projector's operation
manual.)
Note
•
When connecting the projector to the LAN, use
a commercially available LAN cable (UTP cable,
Category 5, cross-over type). When
connecting the projector to a hub, use a
straight-through cable.
1
1
Start Internet Explorer on the
computer.
2
2
Enter "http://" followed by the
projector IP address set by the
procedure on page
"/" in "Address", and then press
the "Enter" key.
•
When "DHCP Client" is set to "OFF" on the
projector, IP address is 192.168.150.2. If you
did not change the IP address in "3. Setting
up a Network Connection for the
Projector" (pages 15-16), enter
"http://192.168.150.2/".
3
3
A screen for controlling the
projector appears, ready for
performing various status
conditions, control, and settings.
16
followed by
-17