Sharp Notevision PG-D40W3D 설정 매뉴얼 - 페이지 28

{카테고리_이름} Sharp Notevision PG-D40W3D에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision PG-D40W3D 35 페이지. True xga/wxga data projectors
Sharp Notevision PG-D40W3D에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사양 시트 (2 페이지), 사양 (2 페이지), 브로셔 및 사양 (2 페이지)

페이지 인쇄

Setting up the Projector Using RS-232C or Telnet

Disconnecting All Connec-

tions

([D]Disconnect All)

It is possible to disconnect all the TCP/IP

connections currently recognized by the

projector. Even if the COM Redirect port is

ﬁ xed in the Busy status due to a problem, it is

possible to force the Ready status back by

carrying out this disconnection.

setup>d

Disconnect All Connections(y/n)?y

Now Disconnecting...

1 Enter "d" and press the "Enter" key.

2 Enter "y" and press the "Enter" key.

Note

•

If Disconnect All is performed, the connection

to the projector via network will be forcibly

disconnected.

Entering ADVANCED

SETUP MENU

([A]Advanced Setup)

Enters ADVANCED SETUP MENU.

setup>a

********************** ADVANCED SETUP MENU *************************

[1]Auto Logout Time

[2]Data Port

[5]Network Ping Test

[6]Accept IP Addr(1)

[7]Accept IP Addr(2)

[9]Accept All IP Addr [0]Search Port

[!]Restore Default Setting

[Q]Return to Main Menu

advanced>

1 Enter "a" and press the "Enter" key.

-28

[8]Accept IP Addr(3)

Setting Auto Logout Time

(ADVANCED[1]Auto Logout Time)

If there is no input after a ﬁ xed time, the

projector automatically disconnects network

connection using the Auto Logout function. It

is possible to set the time until the projector

is automatically disconnected in units of a

minute (from 1 to 65535 minutes).

advanced>1

Valid range

: 0 to 65535 (minute)

note: if you enter "0", auto logout function will be disable.

Auto Logout Time : 5

Please Enter

:15

(change)

—> 15

1 Enter "1" and press the "Enter" key.

2 Enter numerical value and press the

"Enter" key.

Display set numerical value (*).

Note

•

If the set value is made 0, the Auto Logout

function is disabled.

•

If an invalid number is entered, an error

message ("Parameter Error!") will be displayed

and the screen returns to the ADVANCED

SETUP MENU.

Data Port Setting

(ADVANCED[2]Data Port)

Setting of TCP port number. It is possible to

set in the range of 1025 to 65535.

advanced>2

Valid range

:1025 to 65535

Data Port

:10002

Please Enter

:10005

(change)

—>

10005

1 Enter "2" and press the "Enter" key.

2 Enter numerical value and press the

"Enter" key.

Display set numerical value (*).

Note

•

Set according to need. Normally, use with the

factory default setting.