Sharp Notevision PG-D45X3D 설정 매뉴얼 - 페이지 34

{카테고리_이름} Sharp Notevision PG-D45X3D에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision PG-D45X3D 34 페이지. True xga/wxga data projectors
Sharp Notevision PG-D45X3D에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 브로셔 및 사양 (2 페이지)

페이지 인쇄
Sharp Notevision PG-D45X3D 설정 매뉴얼
Troubleshooting
\ Check if the "TCP/IP" protocol is operating correctly using the "PING" command. Also, check
if an IP address is set.
1. Open a command prompt.
2. After launching the command prompt enter a command "PING".
3. When connecting normally, the display will be as follows.
4. When a command cannot be sent, "Request time out" will be displayed.
5. To return to the Windows
\ When the projector cannot be connected, even though the "PING" command is checked:
1. When "Accept IP Address" is set on the projector, set the IP address of the PC to be
2. When a security software is installed on the PC, or when a fi re wall has been set up for the
3. When neither of the above two items applies, change the settings for the data port.
A connection cannot be made because you have forgotten your user name
or your password.
\ Initialize the settings. (See page 51 of the projector's operation manual.)
\ After the initialization, carry out setting again.
-34
•
In the case of Windows
"Command Prompt" in order.
•
In the case of Windows
"Accessories" ➔ "Command Prompt" in order.
Entry example C:\>ping XXX.XXX.XXX.XXX
"XXX.XXX.XXX.XXX" should be entered with an IP address to be connected to, such as the
projector.
(The screen may be slightly different depending on the OS type.)
<Example> when the IP address connected to is "192.168.150.1"
Check the network setting again.
If communication can still not be established properly, contact your network administrator.
connected.
network system, connection may not be possible. Consult the system administrator when,
for example, you want to change the settings to enable use of the TCP port set as the data
port.
2000: click "start" ➔ "Programs" ➔ "Accessories" ➔
®
: click "start" ➔ "All Programs" ➔
®
XP, Windows Vista
®
®
screen, enter "exit" and then press the "Enter" key.