Sharp Notevision XG-C435X-L 설정 매뉴얼 - 페이지 36

{카테고리_이름} Sharp Notevision XG-C435X-L에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision XG-C435X-L 46 페이지. 4000 ansi lumens conference series projector
Sharp Notevision XG-C435X-L에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 사양 (2 페이지)

페이지 인쇄

Setting up the Projector Using RS-232C or Telnet

Disconnecting All Connec-

tions

([D]Disconnect All)

It is possible to disconnect all the TCP/IP connec-

tions currently recognized by the projector. Even if

the COM Redirect port is fixed in the Busy status

due to a problem, it is possible to force the Ready

status back by carrying out this disconnection.

setup>d

Disconnect All Connections(y/n)?y

Now Disconnecting...

1 1 1 1 1 Enter "d" and press the "Enter" key.

2 2 2 2 2 Enter "y" and press the "Enter" key.

Note

• If Disconnect All is performed, the connection to

the projector via network will be forcibly discon-

nected.

Entering ADVANCED

SETUP MENU

([A]Advanced Setup)

Enters ADVANCED SETUP MENU.

setup>a

******************** ADVANCED SETUP MENU ***********************

[1]Auto Logout Time

[2]Data Port

[5]Network Ping Test

[6]Accept IP Addr(1)

[7]Accept IP Addr(2) [8]Accept IP Addr(3)

[9]Accept All IP Addr

[0]Search Port

[!]Restore Default Setting

[Q]Return to Main Menu

advanced>

1 1 1 1 1 Enter "a" and press the "Enter" key.

-36

Setting Auto Logout Time

(ADVANCED[1]Auto Logout Time)

If there is no input after a fixed time, the projector

automatically disconnects network connection using

the Auto Logout function. It is possible to set the time

until the projector is automatically disconnected in

units of a minute (from 1 to 65535 minutes).

advanced>1

Valid range

note: if you enter "0", auto logout function will be disable.

Auto Logout Time : 5

Please Enter

(change)

—> 15

1 1 1 1 1 Enter "1" and press the "Enter" key.

2 2 2 2 2 Enter numerical value and press the "Enter" key.

Display set numerical value (*).

Note

• If the set value is made 0, the Auto Logout func-

tion is disabled.

• If an invalid number is entered, an error message

("Parameter Error!") will be displayed and the

screen returns to the ADVANCED SETUP MENU.

Data Port Setting

(ADVANCED[2]Data Port)

Setting of TCP port number. It is possible to set in

the range of 1025 to 65535.

advanced>2

Valid range

Data Port

Please Enter

(change)

—> 10005

1 1 1 1 1 Enter "2" and press the "Enter" key.

2 2 2 2 2 Enter numerical value and press the "Enter" key.

Display set numerical value (*).

Note

• Set according to need. Normally, use with the fac-

tory default setting.

: 0 to 65535 (minute)

:15

:1025 to 65535

:10002

:10005