Sharp PG-D2710X 설정 매뉴얼 - 페이지 12
{카테고리_이름} Sharp PG-D2710X에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp PG-D2710X 26 페이지. True xga data projector
Sharp PG-D2710X에 대해서도 마찬가지입니다: 운영 매뉴얼 (9 페이지), 빠른 매뉴얼 (2 페이지), 사양 (2 페이지), 사양 (2 페이지), 사양 (2 페이지), 사양 (2 페이지)
페이지 인쇄
Setting up the Projector Network Environment
1. Connecting the Projector
to a Computer
Establishing a one-to-one connection from
the projector to a computer. Using a
commercially available LAN cable (UTP
cable, Category 5, cross-over type) you can
confi gure the projector via the computer.
1
1
Disconnect the computer's LAN
cable from the existing network.
2
2
Connect a commercially available
LAN cable (UTP cable, Category 5,
cross-over type) to the projector's
LAN terminal and connect the
other end of the cable to the
computer's LAN terminal.
3
3
Plug the power cord into the AC
socket of the projector.
4
4
Turn on the computer.
Info
Confi rm that the LINK LED on the rear of the
projector illuminates. If the LINK LED does not
illuminate, check the following:
•
The LAN cable is properly connected.
•
The power switches of both the projector and
the computer are on.
This completes the connection. Now proceed to "2. Setting an IP Address for the Computer".
-12
A LAN cable being
A LAN cable being
connected to the network
connected to the network
LAN cable
LAN cable
(cross-over type, commercially available)
(cross-over type, commercially available)
ON
ON