Sharp PG-M10XE 서비스 매뉴얼 - 페이지 18

{카테고리_이름} Sharp PG-M10XE에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp PG-M10XE 31 페이지. Digital multimedia projector
Sharp PG-M10XE에 대해서도 마찬가지입니다: 운영 매뉴얼 (49 페이지)

페이지 인쇄

PG-M10SU/SE

PG-M10XU/XE

2.Measuring illuminance

Tools required

1. Personal computer (run on Windows 95/98)

2. Projection screen (normally white)

3. Light distribution point display program (Lumens.exe program commonly used for both models UP and U2)

4. Illumination meter

Measuring lumen value

Connect the projector to the PC, and starts lighting.

Start up the light distribution point display program

(Lumens.exe) on the PC. Make the room dark. (A

darkroom is recommended.) Measure the illuminance

at the nine points shown at right. Put the measured

illuminance into the following equation to obtain the

lumen value.

Lumen value (L)

Evenness of illuminance

Put the measured illuminance into the following equation to obtain the evenness of illuminance.

Evenness of illuminance (%) = (The lowest illuminance measured out of 9 points) / (Average illuminance of 9 points)

Peripheral illuminance ratio

Put the measured illuminance into the following equation to obtain the peripheral illuminance ratio.

Peripheral illuminance ratio (%) = (Average illuminance at P1, P3, P7 and P9) / (Illuminance at P5)

The factory settings are as follows.

Model PG-M10X

Lumen value: Min. 500 Lm Evenness of illuminance: Min. 50%

Model PG-M10S

Lumen value: Min. 500 Lm Evenness of illuminance: Min. 50%

= (Average illuminance of 9 points) x (Projected area in m

={(P1+P2+ • • • +P9) / 9} x (A xB)

= [MIN.(P1~P9) / {(P1+P2+ • • • +P9) / 9}] x 100

= {(P1+P3+P7+P9) / 4} / P5] x 100

Peripheral illuminance ratio: Min. 80%

)