Sharp Projector Remote Control 설정 매뉴얼 - 페이지 11

{카테고리_이름} Sharp Projector Remote Control에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Projector Remote Control 29 페이지. Sharp projector remote control setup guide

페이지 인쇄

4.3

If you no longer need the projector, or if it will be turned off for more than 10 minutes,

press the blue power button on the remote. This will turn off the projector. Please

note that you cannot immediately turn the projector back on. It takes a few minutes

for it to cool down and can be turned back on when you see a solid red light on the

projector.

***

To temporarily turn projector off, press MUTE on the remote. Projector will

turn itself back automatically in 10 minutes, or when you press MUTE again.

The following additional steps are necessary only if AUDIO OUTPUT is

required. Please note that the speaker wire kept in the cart's black basket

needs to be connected to either the CPU1 or CPU2 wall plate from the

workstation's speaker port )) (green-colored port on PC).

The volume knob on the PRIMARY CONTROL is for the ceiling speakers. The volume

knob on the RECEIVER is for the speakers on either side of the whiteboard.

5.0

On SWITCHER

5.1

Under the I/O label: Deselect the RGBS button.

5.2

Under the I/O label: Select the Audio button.

5.3

Select the CPU1 or CPU2 button, depending on which wall jack the computer cable

is connected to (CPU1 or CPU2).

5.4

Select button above label for PROJ1 CPU Audio output.

5.5

Press ENTER.

6.0

Clean up

6.1

Power OFF to Projectors.

6.2

Power OFF to PRIMARY CONTROL.

6.3

Power Off to Workstation.

6.4

Disconnect all cables.