Sharp Projector Remote Control 설정 매뉴얼 - 페이지 7

{카테고리_이름} Sharp Projector Remote Control에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Projector Remote Control 29 페이지. Sharp projector remote control setup guide

페이지 인쇄

The following additional steps are necessary only if audio output is

required (the speaker wire, which is attached to the cable kept on the

podium, needs to connected to either the CPU1 or CPU2 wall plate from

the workstation).

Please Note: The volume knob on the PRIMARY CONTROL is for the

ceiling speakers. The volume knob on the RECEIVER is for the speakers

on either side of the whiteboard.

6.0

On SWITCHER

6.1 Under the I/O label: Deselect the RGBS button (light should go off).

6.2 Under the I/O label: Select the Audio button (light should come on).

6.3 Select the CPU1 or CPU2 button, depending on which wall jack the

computer cable is connected to (CPU1 or CPU2) (red light should

come on).

6.4 Select button above label for PROJ1 CPU Audio output (lower left-

hand corner of switcher).

6.5 Press ENTER [right side of switcher].

7.0

Clean up

7.1 Power OFF to Projectors.

7.2 Power OFF to PRIMARY CONTROL.

7.3 Power Off to laptop.

7.4 Disconnect all cables. The laptop cable used to connect the computer

to the wall jack must stay on the classroom's podium.