Sharp XG-V10WLP 네트워크 구성 매뉴얼 - 페이지 3
{카테고리_이름} Sharp XG-V10WLP에 대한 네트워크 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp XG-V10WLP 19 페이지. Operation manual
페이지 인쇄
When installing the expansion cards you must do the following:
1.) Shut projector Off.
2.) Remove the three screws from expansion plate cover. (Refer to Figure A)
3.) Remove (4) four screws that secure the RF shield (Refer to Figure B)
NOTE: Number 2 - Only needs to be done if expansion slot is used for first time.
4.) Remove the cover plate from the optional expansion board that will be installed into the slot.
5.) Insert the expansion board into the connector (Refer to Figure C)
6.) Secure the expansion cover to the board.
Expansion Board Installation
Expansion Slot Closed (with cover)
FIG. A
Screws that secure Expansion Plate cover (Fig A).
3
10/16/2001
L:\tekcentr\CACTrain\SPS_ntwk