Digital Acoustics IP7-STX 시작하기 매뉴얼

{카테고리_이름} Digital Acoustics IP7-STX에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Acoustics IP7-STX 4 페이지.

페이지 인쇄

IP7-ST / STX

Getting Started Guide

Introduction

The IP7-ST/STx IP Intercom endpoint enables 2-way IP audio from an

analog call station with TalkMaster™ software and/or VoIP Systems

supporting industry standard SIP 2.0 (VoIP) protocols. Standard features

include, PoE/External Power, Dual Ethernet ports and Talk/Relay/Sensor

connections.

The ST(x) supports several types of call stations:

• PNL-CISx Single Transducer call stations. Single Transducer call stations

use a single speaker as both a speaker and as a microphone

• Aiphone™ LE / LS series 3-wire call station

• Aiphone™ IE / IF series 2-wire call station

• Call stations with a separate microphone, speaker and Call button

The ST(x) may also be used to drive an Analog Paging Amplifier.

The IP7-ST/STx is configured using TalkMaster Admin Console software.

This Getting Started booklet covers basic hardware installation and software

configuration of the IP7-ST/STx.

IP7-ST/STX Installation

Please refer to the IP7-ST/STx Reference Manual available on the Software

Installation CD for additional information on installation and setup

Important Installation Guidelines

• Use 18-20 AWG shielded, twisted wire for microphone signals

• Use 18 AWG wire for speaker and signaling connections.

• Avoid sharing AC power and audio in conduit runs

• Do not install near power distribution equipment or noise generating

equipment such as stepper motors

• Conform to industry standard practices for grounding

PNL-CISx Single Transducer Call Station Installation

18-20 AWG

Twisted Shielded

(No Connection)

Relay Output (Optional)

2 Conductor Wire

Sensor Input (Optional)

2 Conductor Wire

• Set the internal ST-MIC switch

to the ST setting

• Connect SPKR 8Ω+ and SPKR

8Ω- (J2-6 and J2-7) to the

speaker terminals on the call

station (polarity independent)

• Connect TALK (J2-5) to one

contact on the call station's

TALK button

• Jumper the remaining contact

on the call station's TALK button

to one of the speaker terminals (this wire should be limited to 10ft or 3

meters)

• Connect GND (J2-4) to the shield of the shielded wire. Do not connect the

shield at the door station

Page 1 of 4

PoE / 9VDC - 32VDC

Cat-5/6 Cable to

Network Switch

Talkback Speaker

Talk Button

No Connection