Digital Alert Systems MultiPlayer DASMP 빠른 시작 매뉴얼 - 페이지 13
{카테고리_이름} Digital Alert Systems MultiPlayer DASMP에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Alert Systems MultiPlayer DASMP 13 페이지.
페이지 인쇄Digital Alert Systems
8. Select any of the MultiPlayer GPI's or GPO's you wish to assign to this station holding the SHIFT
key or Control key (Command key for Mac users) for multiple selections.
Refer to the MultiPlayer GPI's & GPO's section of this document for more on ports
9. Click .Submit Selection Settings to save the station settings.
10. Repeat Steps 3-4 thru 3- 9 for each station.
Step 4 – Configuring the MultiPlayer GPI's and GPO's
1. Log in to the DASDEC
2. Go to Setup > GPIO > MultiPlayer GPIO
3. Using the pull down selections to define the action for each input or output.
SELECTIONS ARE IMMEDIATE
4. If you haven't assigned the MultiPlayer GPI's or GPO's to a station you may want to return to
STEP 3 -7 and complete the station action table assignments.
Revision 4.0
Figure 15 MultiPlayer GPI and GPO configuration page. Selections are immediate.
MultiPlayer Quick Start Guide
Use pull-down to select
desired action
Selections are applied
immediately
Repeat on each port as
needed
Page 13 of 13