Digital Alert Systems R232 설치 매뉴얼 - 페이지 6
{카테고리_이름} Digital Alert Systems R232에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Alert Systems R232 8 페이지. Multiport rf router
페이지 인쇄Once the wires are attached to the removable terminal strip it can be connected to
the mating connector in the Pocket Power Supply opening. There are two retention
screws on the terminal strip to secure the connector to the device.
The wires can then be routed along the power cable management tray and toward
the rear of the chassis. The completed connection and wire routing can be seen in
Figure 7 below.
Terminal strip mated to connector
Pocket Power Supply
Figure 7: R232-48VDC side view with DC power cabling installed and properly configured.
Once power connections are made the unit is ready for mounting.
3 Mounting
The R232 is designed to be mounted in a standard Electronic Industries Alliance
(EIA) 19" rack frame using the four mounting screw holes on the front of the chassis.
The 1.75" high chassis is a uniform one rack unit (RU) height.
Chassis Mounting
Holes
The 1.75" (4.45cm) high chassis fills a uniform one rack unit (RU) in height.
1.75 Inches
(4.45 cm)
R232 / R232-48VDC Installation Guide
TM
opening
Figure 8: Front panel mounting holes
Figure 9: R232 rear panel layouts
Power cable management tray
19 Inches (48.3 cm)
Power cabling routed to chassis rear
1U
Page 6 of 8