Digital Aquatics Reef Keeper 설정 매뉴얼 - 페이지 5
{카테고리_이름} Digital Aquatics Reef Keeper에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Aquatics Reef Keeper 6 페이지. For shlobster dosing pumps dosing 2 part
페이지 인쇄function to assign only one timer per channel. Timer 1 to our Part B pump (on channel #1) and
timer 2 to our Part A pump (on channel #4).
Navigate to Channel #1 to begin the programming of the Multi-Timer:
Menu >> Modules >> PC4 >> CH1 >> Function >> Multi-Timer
Timer A with 00 flashes. – Enter the timer # you previously programmed that you would
like CH1 to follow. (Timer 1 in our example)
Timer B with 00 flashes – skip this.
In Standby – set to ignore
Standby Delay – leave at 00:00:00
Default State – set to off.
Save.
Now we want to set our second pump to our second timer:
Menu >> Modules >> PC4 >> CH4 >> Function >> Multi-Timer
Timer A with 00 flashes. – Enter the timer # you previously programmed that you would
like CH4 to follow. (Timer 2 in our example)
Timer B with 00 flashes – skip this.
In Standby – set to ignore
Standby Delay – leave at 00:00:00
Default State – set to off.
Save.
Done!
The only thing left to do now is to check in on the pumps to ensure they are running properly,
and to keep an eye on your water parameters to see if they are increasing or decreasing. If you need
more, you simply go back and edit Timer 1 and Timer 2. In general, we recommend making adjustments
of only 5% at a time. Keep in mind: a) the timer repeats any changes you make 10 times, so for example,
adding 5 seconds of extra time to the timer will add 50 seconds total dosing time each day. b) adding 5%
to the timer will increase the total dose for that channel by 5% as well.