Shimano Bell Crank III 서비스 지침 - 페이지 2
{카테고리_이름} Shimano Bell Crank III에 대한 서비스 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano Bell Crank III 4 페이지.
페이지 인쇄
3.
Set the inner cable onto the pulley.
1)
Insert the inner cable into groove (A) from the inside of the
projection on the pulley, and then pass it through the hole in the
outer casing holder.
Note: Check that the inner cable is correctly routed
along the inside of the projection on the pulley.
Groove (A) in pulley
Projection
on pulley
OK
Hole in outer casing
holder
2)
Hook the inner cable into groove (B) in the pulley, and pull the
inner cable so that the inner cable drum fits into the hole (B) in
the pulley. After this, insert the outer casing into the outer
casing holder.
Groove (B) in pulley
3
Outer casing holder
Hole (B) in pulley
4.
Replace the indicator cover and tighten the cover fixing screw.
Not OK
1
2
Bell crank side
5.
Loosen the cover fixing screw, and then remove the bell crank
cover.
Cover fixing screw
Bell crank cover
6.
Set the inner cable into the link of the main bell crank unit.
1)
Loosen the inner cable fixing nut on the main bell crank unit.
Next, pass the inner cable from the cable adjusting bolt along
the groove in the link and then in between the link and the
inner cable fixing plate.
Cable adjusting bolt
Loosen
Be sure to pass the inner cable
through the groove in the link.
Not OK
OK
Link
Inner cable fixing plate
Inner cable fixing nut