Crestron CNIRHT-30 운영 매뉴얼 - 페이지 11

{카테고리_이름} Crestron CNIRHT-30에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron CNIRHT-30 16 페이지. Hand-held wireless transmitters

CRESTRON CNRFHT-15/30 & CNIRHT-15/30

6. Once the frequency is located, it may be necessary to fine tune the device by slowly turning the tuning tool in

either direction, until the red LED marked SIGNAL is brightly illuminating. The LED must be at its brightest

setting to confirm the unit is tuned to the highest lobe of the frequency range.

7. Move to a different location within the room; depress any button on the transmitter to verify proper frequency

setting.

NOTE

8. If "dead" spots are found within the room, insert the tuning tool into the CNRFHT and carefully make further

adjustments in either direction to fine tune the system.

PROGRAMMING:

A 30-button array is located beneath the custom button panel of each CNRFHT and CNIRHT. Refer to figure 4 for an

illustrative layout of transmitter button numbers beneath a sample button panel. The numbering for each button is

constant. For each button input, a signal name must be defined in the SIMPL program. Unused buttons need not be

assigned signal names. An example following figure 4 illustrates button definition in the CRESNET II Workshop.

Access the following tables from the "Define Network" section of the SIMPL-I Menu. An example of SIMPL-C

programming for the same custom button panel design is shown in the Appendix.

R E M O T E

C O N T R O L

S Y S T E M S

The red LED on the CNRFGW will not illuminate when it is approximately 10 to 15 feet from the

CNRFHT. The system is still functioning, but the threshold to illuminate the signal is too low.

However, the red LED on the CNRFHT illuminates when a button is depressed, indicating the

remote is transmitting.

CRESTRON

Customized button panel removed.

Each button is illustrated with its corresponding number.

Figure 4. Button Number Layout

POWER

CHANNEL

Hand-Held Wireless Transmitters

VOLUME

MUTE

DOC. 8054C