Digital Audio Labs Livemix MT-1 사용자 설명서

{카테고리_이름} Digital Audio Labs Livemix MT-1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Audio Labs Livemix MT-1 2 페이지. Pole mount

POLE MOUNT

Before you begin, locate these features on the MT-1:

1. 2x Threaded knobs (1 3/4" length, 1/4" - 20 thread)

2. 1x Removable V-Clamp piece

3. 2x Captive thumbscrews (thread into CS-DUO or CS-SOLO)

To attach the MT-1 and CS-DUO or CS-SOLO to your mic/music stand

pole:

1. Loosen the threaded knobs to the point where the V-Clamp can

swing freely.

2. Insert the mic/music stand pole between the V-Clamp and the back

of the MT-1.

3. Tighten the threaded knobs evenly until the MT-1 is fastened tightly

to the pole.

4. While holding the CS-DUO or CS-SOLO, slide the CS-DUO or CS-SOLO down the flat face of the

mount so the back wall of the personal mixer catches the alignment surface of the MT-1.

5. Still holding the CS-DUO or CS-SOLO, center it on the MT-1 and thread the thumbscrews into the

personal mixer by hand. If permanent attachment is desired, the thumbscrews can also accommodate

Flathead and Phillips screwdrivers.

6. Route cables through cable management openings.

The pole mount configuration allows a CS-DUO or CS-SOLO to mount on

a microphone stand that is already being used on stage, reducing stage

clutter and eliminating the expense of purchasing dedicated stands for

personal mixers.

The MT-1 is compatible with pole diameters between 3/8" to 1 1/4". This

allows the MT-1 to work with a wide variety of microphone, music and

percussion stands.

MT-1 USER GUIDE

MT-1-1 rev 1.1

1266 Park Road

Chanhassen, MN 55317

952-401-7700