Crestron 3 Series 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Crestron 3 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron 3 Series 8 페이지. Automated processors
Crestron 3 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 (2 페이지), 매뉴얼에서 (2 페이지), 매뉴얼에서 (2 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 운영 매뉴얼 (20 페이지)

페이지 인쇄
Crestron 3 Series 빠른 시작 매뉴얼
CP3 and CP3N
3-Series Control System® Automated Processors
COM 1 Connections
Port
RS-232
G
GND
TX
TX (from CP3/CP3N)
RX
RX (to CP3/CP3N)
RTS
RTS (from CP3/CP3N)
CTS
CTS (to CP3/CP3N)
1. RS-422 transmit and receive are balanced signals that require two lines plus a ground
in each direction. RXD+ and TXD+ should idle high (going low at start of data
transmission). RXD- and TXD- should idle low (going high at the start of data
transmission). If necessary, RXD+/RXD- and TXD+/TXD- may be swapped to maintain
correct signal levels.
2. A ground terminal connection is recommended but not required.
1
RS-422
RS-485
2
GND
GND
TX- (from CP3/CP3N)
TX-/RX-
RX+ (to CP3/CP3N)
Not used
RTS+ (from CP3/CP3N)
TX+/RX+
CTS- (to CP3/CP3N)
Not used
Connect the Control Subnet
(CP3N Only)
The CP3N has a dedicated Control Subnet used for communication
between the control system and Crestron Ethernet devices without
interference from other traffic on the network.
NOTE:
Do not connect the CONTROL SUBNET port to the LAN. The
CONTROL SUBNET port must only be connected to Crestron
Ethernet devices.
For more information on using the Control Subnet, refer to the 3-Series
Control System Reference Guide (Doc. 7150) at
www.crestron.com/manuals.
Quick Start
4