Digital Audio Labs livemix LM-DANTE-EXP2 사용자 설명서 - 페이지 8

{카테고리_이름} Digital Audio Labs livemix LM-DANTE-EXP2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Audio Labs livemix LM-DANTE-EXP2 14 페이지. Dante option card for mix-16/mix-32

페이지 인쇄

SETUP AND OPERATION

INSTALLATION

To install the LM-DANTE-EXP2:

1. Turn off the MIX-16/MIX-32 and disconnect the power

cable.

2. Remove the blank panel on the back of the MIX-16/

MIX-32 by removing the two screws holding it in place.

3. The back of the LM-DANTE-EXP2 has a slotted

connector (see image to the right). This connector

needs to seat into a connector in the MIX-16/MIX-32.

4. Insert the LM-DANTE-EXP2 into the option card slot.

Hold the card by the black panel and gently seat the

connector into the MIX-16/MIX-32. Do not force it, but

feel for gentle resistance as the connectors mate.

5. Reattach the screws removed in step 1 to secure the option card.

PHYSICAL SETUP

Using the Livemix personal monitor system with a Dante

network requires at least one device that is transmitting/

publishing audio to the network. To connect Livemix to the

Dante network, you will need either a Gigabit switch, or a

direct connection to the transmitting device.

At this time, Livemix is a receiving device only. This means

that it can receive and subscribe to channels on the network,

but does not place any audio onto the network.

DIRECT CONNECTION TO DANTE DEVICE

If you have only one additional Dante device like a digital

console, the Dante option card can connect directly to

another Dante enabled device.

1. Connect a CAT5e or CAT6 network cable to the PRIMARY Ethernet connector on the Dante

option card.

2. Connect the opposite end to the PRIMARY Dante connector on the transmitting device.

LIVEMIX DANTE OPTION CARD (LM-DANTE-EXP2)

TERMINOLOGY

Dante terminology is based on

networking terms. When a channel

is PUBLISHED, it is made available

for any device on the network to

SUBSCRIBE to it. You might also

see TRANSMIT and RECEIVE.

It is similar to input and output

in audio terminology. A device

must TRANSMIT its channels by

PUBLISHING them to the network.

The Livemix system will RECEIVE

the channels by SUBSCRIBING to

them.