Digital Barriers EDGEVIS VIDEO ROUTER 4 하드웨어 설치 매뉴얼 - 페이지 15

{카테고리_이름} Digital Barriers EDGEVIS VIDEO ROUTER 4에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Barriers EDGEVIS VIDEO ROUTER 4 16 페이지.

Digital Barriers EDGEVIS VIDEO ROUTER 4 하드웨어 설치 매뉴얼
EDGEVIS VIDEO ROUTER HARDWARE INSTALLATION
FCC Compliance Statement
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with instructions, may cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
The EdgeVis Video Router unit may contain a radio module that has been FCC Approved for fixed and mobile
applications (FCC ID: N7NEM74B Contains transmitter module IC: 2417C-EM74B where 2417C-EM74B is the module's
certification number)
The EdgeVis Video Router may contain a radio module that has been FCC Approved for fixed and mobile applications
(FCC ID: PD9AX201NG).
FCC Warning: changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
To meet the FCC's RF exposure rules and regulations:
The use of a non-shielded interface cable with the EdgeVis Video Router is prohibited
The antenna(s) used with the EdgeVis Video Router must be installed to provide a separation distance of at
least 20cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter
The antenna(s) used with the EdgeVis Video Router encoder, including cable loss, must not exceed 6 dBi at
700 MHz, 850 MHz, 1700 MHz and 1900 MHz; 9 dBi at 2500/2600 MHz; and 1 dBi at 2300 MHz, as defined in
2.1091 for satisfying RF exposure compliance
The EdgeVis Video Router encoder shall only be used for fixed and mobile applications.
ISSUED: 29 NOVEMBER 2022
PAGE 15