Digital Barriers EDGEVIS HD-IP450 설치 매뉴얼 - 페이지 2
{카테고리_이름} Digital Barriers EDGEVIS HD-IP450에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Barriers EDGEVIS HD-IP450 16 페이지.
페이지 인쇄EDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE
Introduction
Before proceeding with the installation and setup of your HD-IP450 unit, please ensure that you check the package
contents listed below, refer to the installation notes on the next page and consult the Quick Start Guide that was
supplied with your unit for step-by-step instructions on preparing hardware and software components.
To operate this device you will need to setup, or have access to, the following architecture:
HD-IP450
To proceed you must have access to an EdgeVis Server, with an account created for the encoder to use. If you do not
have an EdgeVis Server available refer to EdgeVis Server Setup Guide which will walk through the steps required to
install the server and create the necessary accounts required to proceed.
What is in the box?
EdgeVis encoder
Accessories
Printed materials
How do I configure the HD-IP450 unit?
After the introduction, there are three sections in this document that help you to configure your HD-IP450 unit:
Section 1
Section 2
Section 3
Appendix A
Appendix B
ISSUED: 10 NOVEMBER 2020
sends video to
EdgeVis Server
EdgeVis HD-IP450
AC/DC 12V 75W power supply, mains power lead, 2 x 4G antennas, GPS antenna,
Wi-Fi antenna, USB-to-Ethernet adapter
Quick Start Guide
Basic operations of the unit
Powering the unit and connecting devices or drives to the HD-IP450
Configuring communications on the HD-IP450
Connecting to wired, Wi-Fi and cellular networks (including SIM card insertion)
Next steps...
With the HD-IP450 unpacked and wired, what are the steps required to set up the encoder?
Troubleshooting and frequently asked questions
Potential hardware issues that may be encountered with an HD-IP450
Vehicle Installation
Specific guidance on the steps required to install the HD-IP450 in a vehicle
sends video to
EdgeVis Clients
PAGE 2