Digital Barriers EDGEVIS HD-IP250 설치 매뉴얼 - 페이지 5

{카테고리_이름} Digital Barriers EDGEVIS HD-IP250에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Barriers EDGEVIS HD-IP250 14 페이지.

EDGEVIS HD-IP250 HARDWARE INSTALLATION

Powering the device and switching it on/off

The HD-IP250 must be powered using an AC/DC adapter (supplied). To switch the unit on simply connect the output

cable from the AC/DC adapter to the DC input connector on the front panel of the HD-IP250 and connect the AC/DC

adapter to the mains power outlet.

Default LAN port IP Addresses

For ease of deployment each LAN port on the HD-IP250 device is pre-configured with a static IP address:

LAN Port

CAMERA

USB Ethernet

(not supplied)

Connecting IP cameras

The HD-IP250 allows for connection of one IP camera via the CAMERA port located on the front of the unit. The

camera should be connected to the device using standard Ethernet cable and it can be powered by the IP250 PoE

output (Mode A) power supply. The second LAN port is provided to allow separate connections between the HD-IP250

and the IP Camera and internet connection (e.g. an ADSL or SatCom router).

Refer to Section 2 of the IP Series, HD-Q800, 4K-R800 - Setup Guide for details on configuring the Ethernet ports

and IP cameras to work together. The list of specific cameras supported on the IP Series of products can be found on

the Support site:

http://tvi-support.digitalbarriers.com

The HD-IP250 can record video to an external USB storage device. For further details on how to properly prepare a

recording disk refer to Section 2 of the IP Series, HD-Q800, 4K-R800 - Setup Guide.

ISSUED: 10 NOVEMBER 2020

Default IP Address

LAN

192.168.10.1

192.168.11.1

192.168.12.1

Subnet mask

255.255.255.0

PAGE 5