Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G 보충 설명서 - 페이지 6
{카테고리_이름} Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G 12 페이지. Wall plate 4k receiver and room controller 100
Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G에 대해서도 마찬가지입니다: 매뉴얼에서 (2 페이지)
페이지 인쇄
Physical Description
This section provides information about the connectors, controls, and indicators on the front
and rear panels of the DM-RMC-4K-100-C-1G.
Front Panel
The following illustration shows the front panel of the DM-RMC-4K-100-C-1G.
DM-RMC-4K-100-C-1G Front Panel
PWR: Green LED, indicates operating power supplied via PoDM or local power pack
VIDEO: Green LED, indicates video signal presence at the HDMI output
IR OUT: 2-pin 3.5 mm detachable terminal block comprising IR/serial port;*
IR output up to 1.1 MHz;
1-way serial TTL/RS-232 (0-5 volts) up to 19200 baud
COM: 3-pin 3.5 mm detachable terminal block;
Bidirectional RS-232 port;*
Up to 115.2k baud, software handshaking support
HDMI OUT: 19-pin Type A HDMI female;
HDMI digital video/audio output (DVI compatible)
NOTE:
accommodate a DVI signal. The CBL-HD-DVI interface cable is available separately.
*
The IR OUT and COM ports are not supported when the DM-RMC-4K-100-C-1G connects directly to a
DM-TX-4K-100-C-1G; however, video will pass through properly. The IR OUT and COM ports are supported only
when the DM-RMC-4K-100-C-1G connects to an Ethernet-enabled DigitalMedia™ transmitter or switcher that is
addressable from a Crestron control system. When the DM-RMC-4K-100-C-1G connects to a DigitalMedia
switcher, the switcher must be in Private Network Mode (PNM).
2 • DM-RMC-4K-100-C-1G: Wall Plate 4K DigitalMedia 8G+ Receiver
The HDMI OUT port requires an appropriate adapter or interface cable to
Supplemental Guide – DOC. 7725A