Digital Combo DK20S 매뉴얼 - 페이지 13

{카테고리_이름} Digital Combo DK20S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Combo DK20S 20 페이지. Multi-purpose press

The digital pressure/height gauge is calibrated from the factory

to recognize the lowest and highest pressure points settable on the

press. By defining the highest and lowest points of adjustment, the

controller is then able to accurately calculate and display the current

heat platen height & pressure as the operator turns the pressure knob.

It may become necessary to recalibrate the digital pressure/height

gauge if the displayed values of 00 through 10:00 do not properly

correspond to the lowest and highest pressure adjustment levels. This

could happen if the stop collar is loosened to adjust the stopping

position of the heat platen over the lower table. Other factors may

also require the user to redefine the highest and lowest points of

pressure adjustment to the controller.

This is done very easily through the following User Options Menu

items:

Turn the pressure knob to the left to raise

the top head. Do this until the highest level is

reached, without unscrewing the internal bolt

from the main post. Press an arrow key to lock

in that pressure value to PRH. The high point

of the pressure/height gauge is now defined.

Press PRG to move to the next menu item.

Turn the pressure knob to the right to

lower the top head. Do this until the lowest

level is reached. Press an arrow key to lock in

that pressure value to PRL. The low point of

the pressure/height gauge is now defined. Press

PRG to move to the next menu item.