ActronAir ADVANCE EAA17AS 소유자 매뉴얼 - 페이지 4
{카테고리_이름} ActronAir ADVANCE EAA17AS에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActronAir ADVANCE EAA17AS 12 페이지. R-32 ducted systems
페이지 인쇄Owner's Manual
03. Unit Features
Auto-Restart After Power
Failure
Multiple Wall Controller
Operation (Optional)
Room Temp Display with
One Touch
Sense More Technology
Auto Defrost Function
(HEATING Mode)
Hot Start Function
(HEATING Mode)
Filter Clean Light
Self Diagnosis
NOTE
Refer to individual wall controller owner's manuals for a full list of features.
CONTROLLER ONE
4
If the unit loses power, it will automatically restart with prior settings, once power has been
restored.
Up to three wall controllers can be installed on one system. This is particularly useful for larger
houses, where you can have controls in different locations or if multiple sensing points are
required.
Simply press SELECT UP or DOWN button and the set temperature display will change to show the
room temperature for 3 seconds.
Note: When zone sensors are fitted, the temperature displayed will depend on which sensor has
been selected by the wall controller (only applicable to LR7 and LC7-2).
Sense More technology means ActronAir systems come with more temperature sensing points,
which allows them to evenly maintain the temperature throughout your home no matter the time
of day.
At certain outdoor conditions (low temperature) frost may build up on the outdoor heat
exchanger. This gradual build up of frost reduces the performance of the air conditioner. The
microprocessor detects this frost build up and will automatically activate the DEFROST mode.
The DEFROST mode is displayed on the wall controller by flashing the HEAT symbol every 10
seconds.
When the air conditioner starts in HEATING mode, the indoor fan is delayed for a short period
of time, this allows the heat exchanger to warm up before the air starts to flow, thus preventing
excessive cold drafts. The hot start feature also activates itself when the system finishes a defrost
cycle.
The microprocessor monitors the accumulated run time of the air conditioner and after a preset
number of hours has passed, the FILTER light will flash, indicating it is time to check if the filter
needs cleaning.
Note: Only applicable to ActronAir wall controllers.
In the unlikely event that a fault develops with the air conditioner the microprocessor will diagnose
the fault (where possible) and display a fault code on the wall controller.
WALL
Owner's Manual - R-32 Ducted Systems
Doc. No.9590-8000 Ver. 2 220616
R-32 Ducted Systems
WALL
CONTROLLER TWO