Digital Design SS6 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Digital Design SS6에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Design SS6 12 페이지. High performance digital amplifier

Connect the power cables to power terminal + 12V.

All M & S-Class amplifiers are not equipped with fuses so you have to install the external fuses on

the power cable.

Connect one end of fuse holder to the power cable and the other end of fuse holder

to positive battery within 20 cm of the same cable.

This fuse location will protect the system and the vehicle against the possibility of a short circuit in

the power cable. Be sure to use fuses and fuse holder adequate for the application.

GND ( GROUND CONNECTION )

Locate a secure grounding connection as close to amplifier as possible.

Make sure the location is clean and provides a direct electrical connection to the frame of the vehicle.

Connect one end of a short piece of the same size cable as the power cable to the grounding point.

Run the one end of the cable to the grounding point.

Run the other end of the cable to the mounting location

Connect the ground cable to the screw terminal GND.

REM ( REMOTE CONNECTION )

Run a remote turn on cable from the switched + 12V source .

You will be using to turn on the system components.

This may be a toggle switch, a relay, or your source unit's remote trigger cables, or power antenna

trigger cable. Connect the remote turn on cable to the power terminal REM.

Headunit

Ground

Remote Turn on

12V Battery

FUSE RATING

M.80b : 100A ( Linked : 200A )

M1d : 150A ( Linked : 300A )

M2c : 200A ( Linked : 400A )

SS2b : 30A

SS4a : 70A

SS6 : 120A