Digital Electronics PS3650A-T41 매뉴얼 - 페이지 14

{카테고리_이름} Digital Electronics PS3650A-T41에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics PS3650A-T41 20 페이지.

When attaching the HDD to the PS-3651A

IDE I/F

Hardware Setup

The following is the setting method of system information to make BIOS recognize the

hard disk correctly.

• Normally, the factory default settings should be used.

• Certain BIOS screen items may differ from those shown here due to

new versions or the PS-A unit you are using.

(1) Turn off the power switch of the PS-A

unit, remove the power cable. Put the

PS-A on the horizontal place while the

display side of it is downside.

(2) Unscrew the screws (3) of the IDE

cover and remove the IDE cover. Plug

the HDD unit cable connector in the

IDE's interface (Seen the figure on the

left).

(3)

Install the HDD unit like the left

figure, and fix it with the screws (4)

which are contained in your package.

The torque strength for the fixing

should be a range of 0.5 to 0.6 N•m.

(4) Place the IDE cover back and fix it

with the screws (3) of the IDE cover.