Digital Electronics Corporation PLB910-42 설치 매뉴얼 - 페이지 13

{카테고리_이름} Digital Electronics Corporation PLB910-42에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics Corporation PLB910-42 17 페이지.

3) Attach the PL to the Installation Panel with M4 screws.

First, insert the main unit attachment screws into the Installation Panel's

holes, but do not tighten them. Then, place the PL main unit on the panel so

that the bracket holes and the screw heads align. Next, slide the PL down so

that the main unit is supported by these attachment screws. Last, tighten the

screws until the PL is secured in place.

Do not use excessive force when tightening the main unit attach-

ment screws. The torque required is from 0.5 to 0.6N•m.

Main Unit

Attach-

ment

Screws

Wiring the PL

! ! ! ! ! Connecting the power cord

(Side View of PL)

Power Terminals

Power Switch

• To prevent electric shocks, be sure to turn the PL's power supply OFF

before connecting the power cord.

• To avoid the dangers of fire, electric hazards and equipment damage,

be sure to use only the specified power supply voltage when operat-

ing the PL.

PL-B910 (4-Slot Unit)

WARNINGS

Main Unit

Attach-

ment

Screws

Power Input Terminals

Connecting these two termi-

nals provides 100V to 240V

AC power.

L= live and N= Neutral

(screw size: M3)

This terminal is connected

to the PL's frame (chassis).