BITS Smart Strip CCG4 사용자 설명서 - 페이지 3

{카테고리_이름} BITS Smart Strip CCG4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BITS Smart Strip CCG4 8 페이지. Smart strip energy saving smart surge protector

Installing the Smart Strip

LIGHTED POWER SWITCH

This lighted switch is also a 15 Amp circuit breaker. It is normally left on. If it's not lit, turn it on, reset it, or try a different outlet.

GROUND INDICATOR

When this is lit, your equipment is properly grounded & protected. If it is not lit, please try another outlet.

SURGE INDICATOR

When this is lit, your equipment is protected. If it is not, the surge protection has failed. Check http://bitsltd.net/FAQ for details.

CONTROLLED OUTLETS INDICATOR

When this is lit, the ENERGY-SAVING CONTROLLED OUTLETS are on.

MASTER OUTLET

Plug your TV or computer here. This outlet manages the ENERGY-SAVING CONTROLLED OUTLETS. If the device plugged in here is on,

they are on. If it is off, they are also off.

ALWAYS ON OUTLETS

Plug your cable box, satellite receiver, DVR, fax, or cable modem here. These outlets will only turn off with the POWER SWITCH.

ENERGY-SAVING CONTROLLED OUTLETS

Plug in all of your other accessories here. These will turn on or off automatically with the device that is plugged in the MASTER OUTLET.

When the device plugged in to the MASTER OUTLET is off, everything here is electronically unplugged & saving you energy.

You may need to adjust the Smart Strip's sensitivity. This is easy to calibrate with a finger nail or a small screwdriver.

Please wait 2 seconds in between adjustments as some devices may cause a delay before Smart Strip responds.

If the CONTROLLED OUTLETS never turn on:

1. Turn on the device that is plugged into the MASTER OUTLET.

2. Turn the ADJUST dial clockwise in small increments until the CONTROLLED OUTLETS turn on.

3. Turn off the device in the MASTER OUTLET; If the CONTROLLED OUTLETS turn off, you're done.

If the CONTROLLED OUTLETS never turn off:

1. Turn off the device that is plugged into the MASTER OUTLET.

2. Turn the ADJUST dial counterclockwise in small increments until the CONTROLLED OUTLETS turn off.

3. Turn on the device that is on the MASTER OUTLET; if the CONTROLLED OUTLETS turn on, you're done.

- If the above procedure does not work or you have further questions, please consult our web site.

- The ADJUST dial is only a 1 turn dial; please do not force it.

- Some computers take 2 minutes before they enter sleep mode. Adjustments should not be made during this time.

- Risk of electric shock. Do not plug into another relocatable power tap.

The 3rd Generation Smart Strip works with the following devices in the MASTER OUTLET:

- All computers & home entertainment equipment

- All workshop equipment

- 25 Watt or greater incandescent lamps

- 5 Watt or greater fluorescent lamps