Digital Electronics Corporation PS-2000B Series 설치 매뉴얼 - 페이지 16
{카테고리_이름} Digital Electronics Corporation PS-2000B Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics Corporation PS-2000B Series 17 페이지. Windows 2000 multi language preinstalled hard disk unit
Digital Electronics Corporation PS-2000B Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)
페이지 인쇄8
Grouding Cautions
(a) Dedicated Ground
PS-B
(b) Shared Ground - allowed
PS-B
(c) Shared ground - not allowed
PS-B
9
Cautions When Connecting I/O Signal Lines
• I/O signal lines must be wired separately from the power circuit cable. If the
power cord needs to be wired together with the input/output (I/O) signal lines
for any reason, use shielded cord and ground one end of the shield to the PS-
B's FG terminal.
• To improve noise immunity, it is recommended to attach a ferrite core to the
power cord.
Note
Be aware that the Digital Electronics Corporation shall not be held liable for any real or
estimated damages or losses, or third party claims resulting from the use of this product.
© 2002 Digital Electronics Corporation. All rights reserved.
• Set up a dedicated ground when
using the front panel's FG termi-
Other
device
nal.
• If a dedicated ground is not pos-
sible, use a shared ground, as
shown in figure (b).
Other
device
• The grounding point must be as
close to the PS-B as possible, and
the grounding wires must be as
short as possible. If the wires must
be long, use thick, insulated wires
and run them through conduits.
Other
device
• FG and SG terminals are internally
connected in the PS-B. When
connecting to another device, be
sure to create an SG shorting loop
in your system.
057470H
.PS2000B-MT01-BTHE
16
2002.10.
JM/A