Digital Electronics Corporation ST403-AG41-24V 설치 매뉴얼 - 페이지 14

{카테고리_이름} Digital Electronics Corporation ST403-AG41-24V에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics Corporation ST403-AG41-24V 17 페이지.

Connecting the ST Power Cord

When connecting the power cord, be sure to follow the procedures given below.

1. Confirm that the ST's power cord is unplugged from the power supply.

2. Remove the power plug from the ST unit.

3. Remove the vinyl cover of each of the power cord's wires and insert each wire

into the power plug's wire hole.

4. Replace the power plug.

• Use a flat screwdriver (Size 0.6 x 3.5) to tighten the terminal block wire set screws.

The torque required to tighten these screws is 0.5 to 0.6 N•m.

• Do not solder the wire itself.

Terminal block

wire set screws

E-14

Rear of ST

Power Plug