Digital Equipment AlphaStation 600 Series 정보 시트 - 페이지 2
{카테고리_이름} Digital Equipment AlphaStation 600 Series에 대한 정보 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment AlphaStation 600 Series 4 페이지. 333 mhz upgrade
페이지 인쇄5.
Refer to the AlphaStation 600 Series User Information manual and remove the drive assembly.
6.
Refer to the online Digital AlphaStation 600 Series Service Information file and remove the
system board and cache modules.
7.
Unsnap the OCP from the front of the system unit (see Figure 1
Disconnect the ribbon cable connector and the 4-pin twisted-pair cable connector from the OCP
8.
(see Figure 1
) and feed the cables and connectors through the opening in the front of the
system unit into the drive assembly area.
9.
In the drive assembly area, disconnect the 2-pin safety interlock cable connector.
10. In the drive assembly area, unsnap and open the ferrite bead and unwrap the ribbon and
twisted-pair OCP cables from around it.
11. Reach through the drive assembly area to the right side of the system unit and remove the
ribbon and twisted-pair OCP cables from the two cable clips (see Figure 1
cable should remain in the cable clips.
12. While guiding the system board connector ends of the ribbon and twisted-pair OCP cables
through the slot in the bottom right system board area (see Figure 1
twisted-pair OCP cables out through the drive assembly area.
Figure 1: Removing the OCP Cables
13. Place the OCP end of the ribbon and twisted-pair OCP cables on the open ferrite bead so that
the OCP ribbon cable connector and the 4-pin twisted-pair cable connector are 16.51 cm (6.5
in.) from the edge of the ferrite bead.
4
5
3
2
).
). One twisted-pair
), pull the ribbon and
2
1
MLO-011828