Bitspower touchaqua Sedna O11D 설치 매뉴얼 - 페이지 4
{카테고리_이름} Bitspower touchaqua Sedna O11D에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bitspower touchaqua Sedna O11D 5 페이지. For lian li o11 dynamic series
Bitspower touchaqua Sedna O11D에 대해서도 마찬가지입니다: 설치 매뉴얼 (5 페이지), 설치 매뉴얼 (7 페이지), 매뉴얼 (18 페이지), 설치 매뉴얼 (6 페이지)
페이지 인쇄
安裝方式/Installation/安装方式
步驟1/Step 1/步骤1
PC-O11 Dynamic
(不包括/Not included /不包括)
步驟4/Step 4/步骤4
手轉螺帽
Hand tight the nut
手转螺帽
BPTA-WDPO11DA
注意，跑水前，請先確認所有零件已安裝在正確的位置上，在不開主機，單開水泵的情况下，進行24小時的跑水測試， 確保無漏水情况後再開主機，避免發生漏水而導致電腦零件的損壞。
Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test
with only the pump connected to the power supply .
注意，跑水前，请先确认所有零件已安装在正确的位置上，在不开主机，单开水泵的情况下，进行24小时的跑水测试， 确保无漏水情况后再开主机，避免发生漏水而导致电脑零件的损坏。
本公司保留對產品的設計更改以及解釋的權力，如有更動恕不另行通知，產品顏色與配件以實物為準。
Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product.
本公司保留对产品的设计更改以及解释的权力，如有更动恕不另行通知，产品颜色与配件以实物为准。
Sedna O11D for LIAN LI O11 DYNAMIC
步驟2/Step 2/步骤2
頂蓋
TOP
顶盖
M3螺母
M3 Nut
M3螺母
防塵罩
Dust shield
防尘罩
墊片
Gasket
垫片
M3 螺絲
M3 Screw
M3 螺丝
步驟3/Step 3/步骤3
玻璃板
Glass plate
玻璃板
前面板
Front plate
前面板
紅圈處拉釘,需用3mm
鑽頭手動電鑽去除
The circled rivet need to
be removed manually with
a 3mm drill bit.
红圈处拉钉,需用3mm
钻头手动电钻去除
側板
Side plate
侧板
面板
Panel
面板
M2.5 螺絲
M2.5 Screw
M2.5 螺丝