Digital Equipment VAX 4000 600A 설치 체크리스트 - 페이지 6

{카테고리_이름} Digital Equipment VAX 4000 600A에 대한 설치 체크리스트을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment VAX 4000 600A 8 페이지.

2.5 Install the Console Terminal

Did you unpack the console terminal components? (Terminal installation

guide)

Did you connect all console terminal components? (Terminal installation

guide)

Did you turn on the console terminal and observe proper self-tests? (Terminal

owner's manual)

Did you perform setup operations for the console terminal? (Terminal owner's

manual)

Did you turn off the console terminal? (Installation)

Did you connect the console terminal cable from the rear of the console

terminal to the system console module? (Installation)

2.6 Set the System Controls

Did you set the Power switch to off (0)? (Installation)

On each ISE did you set the Write-Protect button to the out (write-enabled)

position and the Run/Ready button to the in (ready) position? (Installation)

Did you verify that a uniquely numbered bus node ID plug is inserted

into each ISE and TF-series or TLZ04 tape drive installed in your system?

(Installation)

Did you set the Halt button to the out (run) position? (Installation)

Did you set the Power-Up Mode switch to Language Inquiry mode (indicated

by a human proﬁle)? (Installation)

Did you make sure that the system and console-terminal baud rate settings

are the same? (Installation)

Did you set the Break Enable/Disable switch to the up (enabled) position?

(Installation)

Does your system have a TK-series or TF-series tape drive? If so, did

you make sure the Cartridge Insert/Release handle is closed (pushed in)?

(Installation)