Bitstream HYPERION-300 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Bitstream HYPERION-300에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bitstream HYPERION-300 7 페이지. Gigabit ethernet industrial switch
Bitstream HYPERION-300에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지)

Bitstream HYPERION-300 빠른 시작 매뉴얼
Quick start manual, a detailed manual is on the enclosed CD
2
P
OWER SUPPLY
Two power inputs - redundant
Voltage range for version 66p 12-36V DC, and for version 77p 20-60V DC
Current consumption 66p for 12V/ 850mA and 36V/ 300mA, and for version 77p 20V/ 520mA
and 60V/ 180mA
Voltage polarity - any for the version without PoE, but for the PoE version as shown below
(changing the polarity does not damage the device)
Screw connection for power supply
3
POE P
OWER SUPPLY
Compliant with the IEEE802.3af standard, IEEE802.3at
The device should be powered with 45-57V DC
The power available on each RJ45 port shall not exceed 30W.
For 55VDC power, the maximum total PoE power is 240W
4
F
IRST START
After connecting power supply with appropriate parameters to the inputs, the PWR LEDs should
light up green in the beginning. If only one of the power supply inputs is used, only one PWR diode
corresponding to this input will light up. The other LEDs indicate that the device is starting up and
is working properly. The device can be managed via any Ethernet port or USB interface via an RS-
232 console.
5
D
EFAULT PARAMETERS
IP parameters:
Adress: 192.168.0.10
User: admin
REV.
V1.12
Fig. 7. Power connector
(
)
OPTION
-
UP
Mask: 0.0.0.0
Password: no password
SHORT USER MANUAL HYPERION-30x
Gate:
0.0.0.0
20 21.03.31
5/7