Digital Equipment Prioris HX 6000 설치 매뉴얼 - 페이지 9

{카테고리_이름} Digital Equipment Prioris HX 6000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment Prioris HX 6000 16 페이지.
Digital Equipment Prioris HX 6000에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지)

페이지 인쇄

If you're installing optional expansion cards

Make sure you are familiar with using:

The System Configuration Utility (SCU)

RAID utilities

The SCSISelect Utility

Refer to your System Reference manual, SCSI, and RAID

manuals for any additional information.

ISA cards should be installed after you run the following

System Configuration Utility since the SCU will list IRQs

already used. PCI and EISA cards should be installed be-

fore running the SCU to take advantage of the SCU's

automatic detection feature.

Use the Quick Launch CD-ROM disk to complete the server

installation. Follow these steps to configure your server.

1. Locate the Quick Launch CD-ROM disk in your Server-

WORKS software kit. Power on your server and insert

the CD-ROM disk. Press Ctrl + Alt + Del to reboot your

server. If your server fails to boot from the CD-ROM,

press Ctrl + Alt + Del again, then Ctrl + A, when

prompted, to run the SCSISelect utility. Enable the

Bootable CD-ROM and INT13 lines, exit and reboot.

Installation Guide

2. Use the SCU, when displayed, to configure the EISA

option cards you installed or to enable the PCI cards.

If you installed ISA cards, check the current card con-

figuration to avoid IRQ conflicts before manually set-

ting jumpers and switches.

Your server automatically reboots after you save and

exit the SCU.

3. If you installed a RAID controller, the RAID configura-

tion utility will be displayed next. Configure your

server for RAID.

NOTE

If you installed additional SCSI or RAID cards, make sure

the MS-DOS partition resides on the drive you want it to

be on. If not, shut down your server, change the order of

your cards and reconfigure your server.