Digital Equipment Prioris Series 설치 매뉴얼 - 페이지 5

{카테고리_이름} Digital Equipment Prioris Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment Prioris Series 15 페이지.
Digital Equipment Prioris Series에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지)

페이지 인쇄

Connect the cables, terminator, and power cord

1. Connect the terminator at the back of the server.

2. Connect the mouse and keyboard cables into the cor-

responding connectors at the back of the server.

3. Place your monitor near your server. Connect the

monitor signal cable to the back of the monitor and

then connect it to the matching connector at the back

of your server. Note that some monitors have cables

permanently attached.

4. Connect the monitor power cord to the back of the

monitor, then to a wall outlet.

5. Connect the server power cord to the server, then to a

wall outlet.

Server Installation

CAUTION

Do not attempt to modify or use an external

100 Vac (Japan only) or 115 Vac power cord for

240 Vac input power. Modifying either cord can

cause severe equipment damage.

The voltage selection switch must match the

voltage supplied by your power outlet. In North

America, 115 volts is common. In other countries,

230 volts is common. Ensure that the voltage

selection switch is set to the right voltage. If it is

not set correctly, you can damage your server.