Bittium OmegaSnap 2-CH ECG 빠른 매뉴얼 - 페이지 2
{카테고리_이름} Bittium OmegaSnap 2-CH ECG에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bittium OmegaSnap 2-CH ECG 2 페이지.
페이지 인쇄
Quick Guide - Bittium OmegaSnap™ 2-CH ECG Electrode
1.
If needed, remove excess body hair
using a razor or an electric shaver.
Clean the skin according to the in-
structions given by your clinic or the
person responsible for treatment.
The skin should be clean and dry
when attaching the electrode.
2.
Make sure the electrode pouch is unopened and check the date
before use. Tear open the pouch and remove the electrode.
3.
2
Remove the plastic liner (marked
as number 1) of the electrode. Do
not touch the adhesive surface
with fingers.
1
2
1
2
4.
Fix the electrode onto the skin.
Place the top of the electrode
2
approx. two fingers' width below
the suprasternal notch. The top
right part of the electrode should
be located below the patient's
right clavicle and the bottom of
the electrode should be above
the diaphragm.
Copyright © 2021-09-07 Bittium. All rights reserved. Document number: 5800646A01
6.
Make sure the surface of the
Faros device and OmegaSnap
adapter are undamaged*.
Connect device to the adapter. To
ensure a good connection, pinch
device and the adapter together
with thumb and index finger.
Attach adapter to the electrode.
Press the device against the
electrode to make sure the snap
fasteners are connected.
7.
Press and release the power
2
button to start measuring. A
sound and blinking green light
indicate that measurement has
started.
*If you notice any visual damage (e.g. a crack or dent), please contact your clinic for
further instructions.
5.
When the top of the electrode is
properly attached, remove the
second liner (marked as number
2) and attach the rest of the
electrode onto the skin.
1x
Quick Guide - Bittium OmegaSnap™ 2-CH ECG Electrode
8.
When you want to end the
measurement, press and hold
the power button for approx.
8 seconds. The device beeps
three times and the blinking
light turns off.
9.
Remove the electrode off the skin by peeling back an edge
of the patch and then gently pulling off the rest of the patch.
You can use mild soapy water if necessary. Dispose of the
used electrode in accordance with local waste management
practices. Return the Faros ECG device and the OmegaSnap
adapter to your clinic or person responsible for treatment.
Symbols
CE mark
Do not reuse
Manufacturing date
Lot number
Manufacturer
Use-by date
Follow instructions for use
Prescription use only**
Medical Device
MD
**USA users please note:
For prescriptions use, use only by designated healthcare professionals
8 sec.