Digital Equipment PrintServer 32 매뉴얼 - 페이지 4
{카테고리_이름} Digital Equipment PrintServer 32에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment PrintServer 32 6 페이지. Controller firmware version 3.6 upgrade
Digital Equipment PrintServer 32에 대해서도 마찬가지입니다: 운영자 매뉴얼 (20 페이지)
페이지 인쇄Installing the Firmware
Installation
Procedure
2
To install the ROM chips:
Disconnect the power cord from the wall outlet and then from
1.
the rear panel.
Open the operator panel cover (
2.
Loosen the two captive screws from the card cage cover and
3.
remove the cover (
Loosen the two captive screws securing the grounding bracket
4.
and remove the bracket (
2
Pull open the release handles on each side of the controller
5.
board (
) and remove the board (
).
).
¡
).
¢
3
).
¡
2
1
1
2