Epson WorkForce WF-3540 빠른 매뉴얼 - 페이지 36

{카테고리_이름} Epson WorkForce WF-3540에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson WorkForce WF-3540 44 페이지. Epson workforce wf-3540 all-in-one printer
Epson WorkForce WF-3540에 대해서도 마찬가지입니다: 지침 (4 페이지), 제품 개요 및 사양 (2 페이지), 사용자 설명서 (13 페이지), (설치 가이드 (4 페이지)

페이지 인쇄

Notices

Important Safety Instructions

Before using your EPSON product, read and follow these safety instructions:

■

Be sure to follow all warnings and instructions marked on the product.

■

Use only the type of power source indicated on the product label.

■

Use only the power cord that comes with the product. Use of another cord may cause fires or

shock. Do not use the cord with any other equipment. Make sure the power cord meets all

relevant local safety standards.

■

Place the product near a wall outlet where the plug can be easily unplugged.

■

If you won't be using the product for a long period, unplug the power cord from the electrical

outlet.

■

Always turn off the product using the

flashing before unplugging the product or cutting off power to the electrical outlet.

■

Avoid plugging the product into an outlet on the same circuit as a photocopier or air

conditioning system that regularly switches on and off, or on an outlet controlled by a wall

switch or timer.

■

Do not let the power cord become damaged or frayed. Place it to avoid abrasions, cuts, fraying,

crimping, and kinking. Do not place objects on top of it and do not allow it to be stepped on or

run over. Be careful to keep the cord straight at each end. If damage occurs to the plug, replace

the cord or consult a qualified electrician.

■

If you use an extension cord with the product, make sure the total ampere rating of the devices

plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the

total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's

ampere rating.

■

When connecting the printer to a computer or other device with a cable, ensure the correct

orientation of the connectors. Each connector has only one correct orientation. Inserting a

connector in the wrong orientation may damage both devices connected by the cable.

■

Place the product on a flat, stable surface that extends beyond its base in all directions. It will

not operate properly if it is tilted or at an angle.

■

Avoid placing the product in locations that are subject to rapid changes in heat or humidity,

shocks or vibrations, or dust. Do not place the product near a radiator or heating vent or in

direct sunlight. Do not place or store the printer outdoors.

■

Keep the product away from potential sources of electromagnetic interference, such as

loudspeakers or the base units of cordless phones.

■

Allow space behind the printer for the cables, and space above the printer so that you can fully

raise the document cover.

Notices

power button, and wait until the

power light stops