Bittree 422A32 사용자 설명서 - 페이지 12
{카테고리_이름} Bittree 422A32에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bittree 422A32 15 페이지. Rs-422 64-port active data patchbay
페이지 인쇄
Port 1 (Controller)
Green
Yellow
LED
LED
Flashing
Off
Flashing
Off
Table 2 – Abnormal conditions and related diagnostic information
Page 12 – Bittree RS-422 64-Port Active Data Patchbay User Guide
Port 2 (Remote)
Green
Yellow
LED
LED
Flashing
Off
Flashing
Flashing
Diagnosis / Possible Causes / Actions
•
Is the remote device turned on, powered up and
plugged into the rear panel DE9 connectors?
•
Is the remote device in "remote" ("slave")
mode?
•
The remote device may be receiving the
controller's commands, but is not responding
(operating) properly.
•
Is the controller successfully controlling the
remote device? If so, the patchbay may be
exhibiting an internal fault. Call Bittree
Customer Service.
•
Is there is a patchcord connected to both Jack 1
and Jack 2? If so, the patchcord may be broken,
or the bantam audio jacks and/or plugs may not
be making good contact. Test the continuity of
the patchcord. Clean the plugs of the patchcord
and try inserting and removing them a few
times. NOTE: Bittree strongly discourages the
use of cleaning sprays or abrasive cleaning tools
on the bantam audio jacks.
•
Is there no patchcord connected to either Jack 1
or Jack 2? If so, the patchbay may be exhibiting
an internal fault. Call Bittree Customer Service.
•
Is the controller successfully controlling the
remote device? If so, the patchbay may be
exhibiting an internal fault. Call Bittree
Customer Service.