Siemens SIMATIC ET 200AL 매뉴얼 - 페이지 20

{카테고리_이름} Siemens SIMATIC ET 200AL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC ET 200AL 38 페이지. 10-link digital output module dq 8x24vdc/2a 8xm12
Siemens SIMATIC ET 200AL에 대해서도 마찬가지입니다: 매뉴얼 (50 페이지), 매뉴얼 (38 페이지), 매뉴얼 (32 페이지), 매뉴얼 (37 페이지), 장비 매뉴얼 (46 페이지), 매뉴얼 (26 페이지), 장비 매뉴얼 (28 페이지), 장비 매뉴얼 (27 페이지), 매뉴얼 (25 페이지)

페이지 인쇄
Siemens SIMATIC ET 200AL 매뉴얼
Parameters/address space
4.1 Parameters
The following table shows the port parameters for the communication module
CM 4xIO-Link 4xM12 with firmware version V1.1.
Table 4- 2
Parameters
Port configuration
Operating mode
Length of input data
(without PQI)
Length of output data
Vendor ID**
Device ID**
Testing accuracy / data
storage**
* Take care not to exceed the maximum possible length of the input or output data for all ports.
Example:
You have selected the 32I/32O configuration. You have assigned the first port 16 bytes of input
data.
You can still assign a total of 16 bytes of input data for the remaining three ports.
** Only in effect when "IO-Link manual" port mode is used.
20
Port parameters
Range of values
IO-Link autostart
•
IO-Link manual
•
DI
•
DQ
•
Disabled
•
Depending on the total length of
the module*
Depending on the total length of
the module*
Vendor ID of the connected
IO-Link device
Device ID of the connected
IO-Link device
Same type (V1.0) without
•
Backup&Restore
Type compatible (V1.1)
•
without Backup&Restore
Type compatible (V1.1) with
•
Backup&Restore
Type compatible (V1.1) with
•
Restore
Communication module CM 4xIO-Link 4xM12(6ES7147-5JD00-0BA0)
Default
IO-Link autostart
Depending on the total length of
the module*
Depending on the total length of
the module*
0
0
Type compatible (V1.1) with
Backup&Restore
Manual, 10/2017, A5E32352322-AE