Siemens SIMATIC ET 200AL 매뉴얼 - 페이지 44

{카테고리_이름} Siemens SIMATIC ET 200AL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC ET 200AL 50 페이지. 10-link digital output module dq 8x24vdc/2a 8xm12
Siemens SIMATIC ET 200AL에 대해서도 마찬가지입니다: 매뉴얼 (38 페이지), 매뉴얼 (38 페이지), 매뉴얼 (32 페이지), 매뉴얼 (37 페이지), 장비 매뉴얼 (46 페이지), 매뉴얼 (26 페이지), 장비 매뉴얼 (28 페이지), 장비 매뉴얼 (27 페이지), 매뉴얼 (25 페이지)

페이지 인쇄
Siemens SIMATIC ET 200AL 매뉴얼
7.2

Response of the analog input module

Requirement
You can use the PROFIenergy function when you use the internal encoder supply.
Display
The channel status LEDs are not affected by PROFIenergy.
Response to error detection
All channels that are in pause mode on "PE_MODE_PROCEED" report their diagnostic
status as in productive mode.
The following applies for all channels which switch to a different pause mode:
● Encoder supply switch-off upon the start of "pause" does not result in the alarm "Wire
break".
● "Wire break", "Short circuit", "High limit violated" and "Low limit violated" error detection is
not possible during the "pause":
– Alarms for errors already pending before the "pause" are retained.
– After the "pause" is over, the error status is updated and incoming/outgoing errors are
● Hardware interrupts are not signaled.
Analog input module AI 4xU/I/RTD 4xM12 (6ES7144-5KD00-0BA0)
Manual, 08/2018, A5E32350124-AD
reported correspondingly.
7.2 Response of the analog input module
PROFIenergy
43