Siemens SIMATIC ET 200AL 매뉴얼 - 페이지 17

{카테고리_이름} Siemens SIMATIC ET 200AL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC ET 200AL 38 페이지. 10-link digital output module dq 8x24vdc/2a 8xm12
Siemens SIMATIC ET 200AL에 대해서도 마찬가지입니다: 매뉴얼 (38 페이지), 매뉴얼 (50 페이지), 매뉴얼 (32 페이지), 매뉴얼 (37 페이지), 장비 매뉴얼 (46 페이지), 매뉴얼 (26 페이지), 장비 매뉴얼 (28 페이지), 장비 매뉴얼 (27 페이지), 매뉴얼 (25 페이지)

페이지 인쇄
Siemens SIMATIC ET 200AL 매뉴얼
Hardware interrupt
Ending a "Pause" causes hardware interrupts to be detected again.
"Pause" behavior under certain operating conditions
A "Pause" is ended in the following cases:
Table 2- 2
Ending a "Pause"
The supply voltage 1L+ of the interface module module
has failed.
•
•
•
•
•
The I/O module was pulled and plugged
Station stop
•
The supply voltage 1L+ of the I/O module has failed
The parameter settings of the I/O module were
changed during operation using data record 128
The substitute value behavior was activated.
1
Interface module IM 157-1 PN (6ES7157-1AB00-0AB0)
Manual, 12/2016, A5E32347036-AD
Ending a "Pause"
Stop controller
1
Controller failure (connection interrupted)
Firmware update
Reset to factory settings
Deactivating the IO device
1
Removing an I/O module
1
1
Explanation
The "pause" is exited and can be re-
activated by re-sending the PROFIenergy
parameter assignment followed by the
"Start_Pause" command.
The "pause" is exited , the PROFIenergy
parameter assignment is still on the I/O
module and the "pause" can be re-activated
by the "Start_Pause" command.
Product overview
2.3 Functions
17