Siemens SIMATIC ET 200SP HA 장비 매뉴얼 - 페이지 40

{카테고리_이름} Siemens SIMATIC ET 200SP HA에 대한 장비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC ET 200SP HA 50 페이지. Distributed i/o devices busadapter for distributed i/o
Siemens SIMATIC ET 200SP HA에 대해서도 마찬가지입니다: 매뉴얼 (32 페이지), 매뉴얼 (50 페이지), 매뉴얼 (34 페이지), 매뉴얼 (38 페이지), 장비 매뉴얼 (44 페이지), 장비 매뉴얼 (38 페이지), 장비 매뉴얼 (46 페이지), 장비 매뉴얼 (42 페이지), 장비 매뉴얼 (44 페이지), 장비 매뉴얼 (36 페이지), 장비 매뉴얼 (38 페이지)

페이지 인쇄
Siemens SIMATIC ET 200SP HA 장비 매뉴얼
Technical specifications
8.1 Technical specifications
Minimum pulse length
In order for a pulse or an edge transition to be reliably detected by the I/O module or the partner
module (at IO redundancy failover), the signal status must be active for at least for the time
period of the minimum pulse length.
Operating mode
Stand-alone operation
I/O redundancy mode
Each edge transition is detected after a delay of no more than the specified minimum pulse
length. This has a corresponding effect on the time stamps for SoE (Sequence of Events),
Redundancy failover time
With an I/O redundancy failover, the update time of the process values or the detection of an
edge transition is delayed once by a maximum of this time.
The redundancy failover time of the I/O module is 40 ms + input delay.
NAMUR encoders and connected contacts
Monitoring for short-circuit and wire break only for NAMUR encoders and connected contacts.
The response ranges of the diagnostics correspond to IEC 60947-5-6.
40
Minimum pulse length
Input delay + cycle time
40 ms + 2x input delay + 2 x cycle time
Equipment Manual, 08/2019, A5E39293880-AD
DI 16xNAMUR HA